Stella CTMH Paper Interactive Card

Hello stampers!
What a beautiful Saturday afternoon. This slider cake is created out of the Stella CTMH paper along with pewter badge buttons. Colonial white card stock for the frosting. For the slider part of the cake each top section slides down into the below section to the main base part of the cake like a pocket.  This is cute for a wedding card or a birthday card.

Tools:

Brads 1 decorative, 2 rectangle

Punch decorative border, 1 1/8" circle punch

  1/16" hole punch, Flower

scoring tool

Craft knife

Double sided tape ( I used red line)

Sentiment Stamps

For the bottom tier:  Cut 1@  11 X 3 1/2"piece of Stella card stock. Score at 1/2" and 5 3/4" from left edge.

Middle tier: Cut 1 @ 8 5/8"X 3 1/8" Stella card stock Score 1/2" and 4 5/8" from left edge.

Top tier: Cut 1 @ 5 3/4" X 3" Stella card stock score 1/2" and 3 1/8" from the left edge.

using the circle punch to create a notch at the center top edge of middle and bottom tiers. Punch a border punch from colonial card stock and adhere to top edge of each notched tier and then re punch notches. NOTE: this will be easier then trying to notch through all the layers. Punch another border to fit the top tier and adhere to the top edge.

In center of right- handed panel of the middle teir,beginning 3/4" inch from top edge, cut a 1 1/2" inch long slit approoximately 1/16" inch wide.

Repeat in the cent of right handed panel of the bottome tier, beginning 1/2" inch from the top edge and cutting a slit 2 3/4" inches long.

Fold tio tier on scored lines and place inside of the middle tier,centered between score lines with top edges even. Fol middle tier over top tier and place a mark through slit toward the bottom of top piece. Remove top tier from the middle tier and unfold. Punch a small hole at mark just made. Insert a rectrangular brad through slit in middle tier and punched hole on top tier, Bend ends of flat to fasten two tiers together.

Use a punch flower punch from cordinating card stock. Punch a whole in the middle and place decorative brad in the center. Adhere end to top tier together.

Punch a hole in back of the middle tier 1/4" below bottom of slit. Attache with a rectangle brad through slit in bottom tier adhere ends of the middle and bottom tiers to complete.